Featured Image. Ball-pythons.net
Whether you’re incubating ball python eggs for the first time, or have been doing so for a number of years, it’s important to know and understand what conditions are best during the incubation process.
Improper or too much heat or humidity will cause your baby snakes to die.
This Ball Python Incubation Guide focuses on providing you with easy-to-use instructions, tips, and guidelines to help you properly incubate ball python eggs.
What is the ball python incubation temperature?
The ball python incubation temperature is typically around 80 degrees Fahrenheit.
It’s important that you keep the temperature stable at this level.
It’s also important to maintain a high level of humidity during this time.
Humidity for your incubation chamber should be around 60 to 70 percent, and you should use a hygrometer to monitor it during this process.
Ball Python Egg Incubation Temp and Humidity
What is the ball python egg incubation temperature?
The ball python incubation temperature is a critical factor in the successful hatching of your eggs.
It is important that you have a thermometer to monitor the temperature and do not rely on a thermostat as they are often inaccurate.
The ideal temperature range for ball python eggs is 86F-90F (30C-32C).
This temperature can be maintained by using an under-tank heater or heat tape attached to the side of the tank.
Any higher than this and you risk cooking your eggs, so it is important to keep the temperature stable at all times.
What is the best humidity for ball python Egg incubation?
Humidity is another important factor when breeding ball pythons and can affect the rate at which your eggs will hatch.
It is recommended that you keep your tanks around 65-75% humidity, which can be done by adding moss into the incubator tank or placing water bowls within the tank.
If there are no water bowls present then misting with water can help increase humidity levels but make sure it doesn’t drip down onto any eggs!
How to keep your incubator at the right temperature and humidity during the incubation process.
The answer to this question is that you need to monitor the thermometer and hygrometer in your incubator on a regular basis, but it is not too difficult.
If you have an incubator that has a built-in thermostat, all you need to do is set it at 88 degrees F (31 degrees C) and leave it alone.
The built-in thermostat should keep your eggs at that temperature without any problem. If you are using an incubator without a built-in thermostat, then you will need to use a digital thermometer and digital hygrometer (moisture gauge).
The best way to use these devices is to set up your incubator for hatching, plug in both devices, and place them inside the egg chamber of your incubator.
Close all doors and lids tightly so no air leaks out. Make sure there are no holes in any part of your incubation chamber as well! Once everything is closed up tight, turn on your lights if applicable.